Chapter 1
User Interface
1-22
ni.com
4.
As you make changes to the layer settings, the
Allowed Vias
pane
shows the acceptable layer combinations for blind and buried vias or
microvias. Use the checkboxes to select the layer combinations you
want to allow in your design as shown in the example in the figure
below.
5.
In the
Allow Routing
area, from the
Copper Layer
drop-down list,
select the copper layer for which you wish to assign routing properties
and click
Properties
to display the
Copper Layer Properties
dialog
box.
Enable the
Routable
checkbox to allow routing on the selected layer.
In the
Trace Bias
drop-down list, select one of
Horizontal
;
Vertical
;
or
None
.
Click
OK
to close the
Copper Layer Properties
dialog box.
6.
In the
Board
area, enter the desired
Board Outline Clearance
and
Board Thickness
.
7.
Click
OK
to close the dialog box.
Pads/Vias Tab
Use the
Pads/Vias
tab of the
PCB Properties
dialog box to set the
following:
•
•
•
•
•
