Chapter 1
User Interface
©
National Instruments Corporation
1-47
Commands Tab
The
Commands
tab in the
Customize
dialog box is used to add commands
to menus and toolbar.
Complete the following steps to add a command to a menu or toolbar:
1.
Drag the desired command from the
Commands
list to the desired
menu or toolbar. When a command is selected in the
Command
list,
its description is displayed in the
Description
field.
2.
If you do not see the command that you require, click on another
selection in the
Categories
list to display more commands.
3.
If you wish to add a button to a toolbar that is not showing, click on the
Toolbars
tab and click in the checkbox beside the desired toolbar to
make it visible.
4.
Click
Close
when customizations are complete.
To remove a command from a menu or toolbar, right-click on it and select
Delete
from the pop-up that appears. The
Customize
dialog box must be
open when you do this.
To change the position of a command that is in a menu or toolbar, drag it to
its new location. The
Customize
dialog box must be open when you do
this.
Toolbars Tab
The
Toolbars
tab in the
Customize
dialog box is used to show or hide
toolbars, and to add new custom toolbars.
Complete the following steps to use the features in this tab:
1.
To display a toolbar, switch on the checkbox beside the desired toolbar
in the
Toolbars
list.
2.
Switch off a checkbox to hide a toolbar.
Note
You cannot switch off the
Menu
bar.
