Chapter 4
Working with Parts
4-30
ni.com
4.
Indicate the pad type (THT or SMD) and its dimensions and spacing.
Changes appear in the
Preview
panel. When you have made the
necessary settings, click
OK
. The pad is attached to the pointer. Click
on the part to place it.
5.
When finished, choose
Edit»In-Place Part Edit
again to end the
In-Place Edit
function. The part appears with its changes.
Note
You can save your edited part in the database for future use. Refer to the
Parts using the Add Selection to Database Command
section for more information.
Editing a Polygon
A vertex is a point of a polygon. You can add or remove vertices from
polygons, whether copper or non-copper.
