Chapter 2
Hardware Installation
MXI-Express x16 for PXI Express Series User Manual
2-2
ni.com
Note
The NI PCIe-8388 requires a host computer that supplies a PCI Express clock that
adheres to the
PCI Express Specification
. The NI PCIe-8388 may not be compatible with
systems with noncompliant clocks, and requires the clock to exceed certain specifications.
Therefore, only certain host PCs are supported for use with the NI PCIe-8388. Refer to
KnowledgeBase 5J9C7371 for more information about supported host PCs.
5.
Locate the metal PCI Express filler panel that covers the cut-out in the
back panel of the computer for the slot you have selected. Open the
bracket retention latch or remove and save the bracket-retaining screw
(if applicable) and the PCI Express slot filler panel.
6.
Align the NI PCIe-8388 with the slot on the back panel. Slowly slide
the NI PCIe-8388 until its board-edge connector is touching the
expansion slot receptacle. Using slow, evenly distributed pressure,
press the NI PCIe-8388 until it seats in the expansion slot.
7.
Close the PCI Express board retention latch or reinstall the retaining
screw (if applicable) to secure the NI PCIe-8388 to the back panel rail.
8.
Replace the computer cover.
Installing an NI PXIe-8388/9
Complete the following steps to install the NI PXIe-8388/9 in your
PXI Express or CompactPCI Express chassis.
Note
The NI PXIe-8388/9 must be installed in the controller slot (slot 1 in PXI Express).
1.
Touch a metal part of the chassis to discharge any static electricity that
might be on your clothes or body.
2.
Power off your PXI Express or CompactPCI Express chassis and
unplug the power cord.
Caution
To protect both yourself and the chassis from electrical hazards, leave the chassis
off until you finish installing the NI PXIe-8388/9.
3.
Remove or open any doors or covers blocking access to the slot where
you intend to install the NI PXIe-8388/9.
4.
Make sure the injector/ejector handle is in its downward position.
Be sure to remove all connector packaging and protective caps from
retaining screws on the module. Align the NI PXIe-8388/9 with the
board guides on the top and bottom of the system controller slot.
