NI RF Signal Generators Getting Started Guide
16
ni.com
Figure 6.
Torque All SMA Connectors to 100 N-cm
4.
Power up the PXI chassis and controller system.
5.
Verify that the ACCESS LEDs on both modules are illuminated. If the
LEDs are not illuminated, refer to
7. Configuring NI RF Signal Generators in MAX
Use Measurement & Automation Explorer (MAX) to configure your
National Instruments hardware. MAX informs other programs about which
devices reside in the system and how they are configured. MAX is
automatically installed with NI-RFSG.
Configuring the NI 5670/5671/5672 in MAX
Note
MAX treats the NI 5610 upconverter module and the NI 5421/5441/5442
AWG
module as separate but associated devices. The MAX association is necessary for
1
100 N-cm SMA Torque Wrench
2
Apply Force Here Until Wrench Clicks
1
2
