©
National Instruments Corporation
21
NI RF Signal Generators Getting Started Guide
4.
Click
Stop
to stop waveform generation.
5.
Click
Close
to return to MAX.
6.
Exit MAX.
You have completed setup, configuration, and testing of the
NI 5650/5651/5652 RF Signal Generator.
8. Setting up Synchronization for NI-DAQmx Devices
in MAX
If you plan to share triggers or clocks to synchronize NI-DAQmx devices,
you must identify or configure certain components in MAX.
Note
The following steps are required for any type of synchronization involving an
NI-DAQmx device.
♦
PXI devices
—identify the PXI system controller by completing the
following steps:
1.
In the MAX configuration tree under
Devices and Interfaces
,
right-click
PXI System
»
Identify As
and select your controller from
the list. For example, select
External PC
if you are using a MXI-3 or
MXI-4 controller in an external PC.
2.
Expand the PXI System tree and select the chassis name to identify the
chassis you are using.
♦
PXI Express devices controlled via MXI-Express
—in the MAX
configuration tree under
Devices and Interfaces
, right-click
PXI
System»Identify As
and select
External PC
. Your chassis will be
automatically identified.
♦
PXI Express controller
—a PXI Express controller installed in a PXI
Express chassis is automatically identified in MAX.
9. Programming the RF Signal Generator
You can generate signals with the NI RF signal generator using the
NI-RFSG instrument driver. You also can run the NI-RFSG examples
to demonstrate the functionality of the NI RF signal generator.
