©
National Instruments Corporation
35
NI RF Signal Generators Getting Started Guide
24. Verify that the VI front panel looks like the example in Figure 20.
Figure 20.
Basic Sine Wave Generation VI Front Panel Using NI 5670/5671/5672
Note
Populate the
resource name
control
with the NI 5610 upconverter module name
(refer to the
section for more information) or the
NI 5650/5651/5652 name specified in MAX.
25. Click the
Run
icon on the VI taskbar to initiate sine wave generation.
26. Click the VI front panel
STOP
button to stop sine wave generation.
You have successfully generated a continuous sine wave signal using the
NI-RFSG driver software and the NI RF signal generator hardware.
Appendix C: Troubleshooting
Module Front Panel ACCESS LED is Off When PXI Chassis is On
If the ACCESS LED fails to illuminate after you power on the PXI chassis,
a problem may exist with the PXI power rails, a hardware module, or
the LED.