National Instruments NI 5741, Getting Started Manual

Installing the NI FlexRIO Devices............................................................................................6

Installing the NI FlexRIO Adapter Module...................................................................... 6

Connecting Cables.................................................................................................................... 7

Removing the Adapter Module.................................................................................................8

Disabling the Adapter Module in LabVIEW FPGA.........................................................8

Uninstalling the Module....................................................................................................8

Installing Accessories............................................................................................................... 8

Appendix A: NI 5741 Features................................................................................................. 9

Front Panel and Connector Pinouts...................................................................................9

Block Diagrams...............................................................................................................11

Appendix B: Interfacing with the NI 5741............................................................................. 12

Component-Level Intellectual Property (CLIP)............................................................. 12

Clocking.......................................................................................................................... 15

Where to Go Next................................................................................................................... 15

Worldwide Support and Services............................................................................................ 16

Electromagnetic Compatibility Guidelines

This product was tested and complies with the regulatory requirements and limits for

electromagnetic compatibility (EMC) stated in the product specifications. These requirements

and limits are designed to provide reasonable protection against harmful interference when the

product is operated in the intended operational electromagnetic environment.
This product is intended for use in industrial locations. However, harmful interference may

occur in some installations, when the product is connected to a peripheral device or test object,

or if the product is used in residential or commercial areas. To minimize interference with

radio and television reception and prevent unacceptable performance degradation, install and

use this product in strict accordance with the instructions in the product documentation.
Furthermore, any modifications to the product not expressly approved by National Instruments

could void your authority to operate it under your local regulatory rules.

Caution

To ensure the specified EMC performance, operate this product only with

shielded cables and accessories.

Note

To ensure the specified EMC performance, the length of all I/O cables must

be no longer than 30 m (100 ft).

How to Use Your FlexRIO Documentation

Refer to the following flowchart for information about how to use FlexRIO documentation.

2

  | 

ni.com

  | 

NI 5741 Getting Started Guide