16
|
ni.com
|
NI 5782R User Manual and Specifications
Your block diagram should resemble the block diagram in Figure 7.
Figure 7.
5782SampleAcq(Host).vi Block Diagram
16. Save the VI as
5782SampleAcq(Host).vi
.
Running the Host VI
1.
Connect one end of an SMA cable to AI 0 on the front panel of the NI 5782 and the other
end of the cable to your DUT.
2.
Open the front panel of
5782SampleAcq(Host).vi
.
3.
Click the
Run
button to run the VI.
4.
The VI acquires data from the DUT on
AI 0
,
AI 0 N-1
,
AI 1 N
, and
AI 1 N-1
.
5.
Click the
STOP
button on the front panel and close the VI.
Appendix A: Specifications
This section lists the specifications of the NI FlexRIO adapter module (NI 5782). Pair these
specifications with the specifications listed in the
NI FlexRIO FPGA Module Installation Guide
and Specifications
. For more information about safety and electromagnetic compatibility refer
to the
Read Me First: Safety and Electromagnetic Compatibility
document included in your
hardware kit or available at
ni.com/manuals
.
Caution
To avoid permanent damage to the NI 5782, disconnect all signals
connected to the NI 5782 before powering down the module, and only connect
signals after the module has been powered on by the NI FlexRIO FPGA module.
Note
All numeric specifications are typical unless otherwise noted. All graphs
illustrate the performance of a representative module.
Specifications are subject to change without notice. For the most recent device specifications,
visit
ni.com/manuals.
