Index
I-4
ni.com
ground-referenced signal sources
description, 4-7
differential connections, 4-11
single-ended connections (NRSE
configuration), 4-15 to 4-16
H
hardware installation
procedure, 2-1 to 2-2
unpacking 6013/6014 device, 1-4
hardware overview
analog input, 3-2 to 3-4
input mode, 3-2
scanning multiple channels,
3-3 to 3-4
analog output, 3-4
block diagram, 3-1
digital I/O, 3-4 to 3-5
timing signal routing, 3-5 to 3-6
programmable function inputs, 3-6
I
input mode.
See
analog input modes.
input range
exceeding common-mode input ranges
(caution), 4-8
measurement precision (table), 3-3
overview, 3-3
installation
categories of installation, 1-6 to 1-7
procedure, 2-1 to 2-2
questions about, C-2
software installation, 2-1
unpacking 6013/6014 device, 1-4
I/O connectors, 4-1 to 4-6
cables for use with I/O connectors
(table), 4-1
correspondence of signal names in
LabVIEW and NI-DAQ (table), C-7
exceeding maximum ratings
(caution), 4-1
optional connectors, B-1 to B-3
50-pin connector pin assignments
(figure), B-3
68-pin connector pin assignments
(figure), B-2
pin assignments (figure), 4-2
signal descriptions (table), 4-3 to 4-5
signal summary (table), 4-5 to 4-6
L
LabVIEW Data Acquisition VI Library, 1-3
LabVIEW software
correspondence of signal names in
LabVIEW and NI-DAQ (table), C-7
overview, 1-3
LabWindows/CVI software, 1-3
M
manual.
See
documentation.
maximum working voltage specifications, A-9
Measurement Studio software, 1-3
multiple channel scanning
description, 3-3 to 3-4
questions about, C-4
N
NI 6013/6014 device.
See also
hardware
overview.
block diagram, 3-1
configuration, 2-2 to 2-3
optional equipment, 1-4
overview, 1-1
questions about, C-1 to C-7
requirements for getting started, 1-1 to 1-2
safety information, 1-5 to 1-7
software programming choices, 1-2 to 1-4
