National Instruments NI 9157, Operating Instructions And Specifications

©

 National Instruments Corporation

17

NI 9157/9159 Operating Instructions and Specifications

NI 9159

FPGA type ...................................... Virtex-5 LX110

Number of flip-flops ....................... 69,120

Number of 6-input LUTs ................ 69,120

Number of DSP48 slices
(25 



 18 multipliers) ....................... 64

Embedded block RAM ................... 4,608 kbits

Timebases............................................... 40, 80, 120, 160, or 200 MHz

Accuracy ......................................... ±100 ppm (max)

Frequency dependent jitter (peak-to-peak)

40 MHz .................................... 250 ps

80 MHz .................................... 422 ps

120 MHz .................................. 422 ps

160 MHz .................................. 402 ps

200 MHz .................................. 402 ps

Power Requirements

Caution

You must use the NI 9157/9159 with a 9 to 30 VDC output, UL Listed, limited 

power source (LPS) supply. The power supply must bear the UL Listed and LPS marks. 
The power supply must also meet any safety and compliance requirements for the country 
of use.

Recommended power supply ................. 55 W, 30 VDC max

Voltage requirement............................... 9 to 30 V

Chassis power consumption/dissipation

NI 9157

With no I/O modules ............... 14.4 W (max)

With 14 I/O modules ............... 30.7 W (max)

NI 9159

With no I/O modules ............... 16.25 W (max)

With 14 I/O modules ............... 32.7 W (max)

Note

The power consumption specifications in this document are maximum values for a 

LabVIEW FPGA application compiled at 80 MHz. Your application power requirements 
may be different. To calculate the power requirements of the NI 9157/9159, add the power 
consumption/dissipation for the chassis and the I/O modules you are using. Keep in mind 
that the resulting total power consumption is a maximum value and that the NI 9157/9159 
may require less power in your application. For more information about the I/O module 
power requirements, refer to the module operating instructions.