Figure 11.
Power Connector
C
NC
C
V
2
1
2
1. Terminal Screws
2. Connector Screws
2. Connect the negative lead of the power supply to one of the C terminals of the power
connector and tighten the terminal screw.
3. Optionally, you can connect the positive lead of another power supply to the other V
terminal and the negative lead to one of the C terminals.
4. Install the power connector on the front panel of the cRIO-9074XT and tighten the
connector screws.
Powering On the cRIO-9074XT
When you apply power to the cRIO-9074XT, the controller runs a power-on self test (POST).
During the POST, the Power and Status LEDs turn on. The Status LED turns off, indicating
that the POST is complete. If the LEDs do not behave in this way when the system powers on,
refer to the
You can configure the cRIO-9074XT to launch an embedded stand-alone LabVIEW RT
application each time you boot the controller. Refer to the
LabVIEW Help
for more
information.
Chassis Reset Options
The following table lists the reset options available on CompactRIO systems such as the
cRIO-9074XT. These options determine how the chassis behaves when the controller is reset
in various conditions. Use the RIO Device Setup utility to select reset options. Access the RIO
Device Setup utility by selecting
Start
»
All Programs
»
National Instruments
»
NI-RIO
»
RIO
Device Setup
.
NI cRIO-9074XT User Manual and Specifications
|
© National Instruments
|
11
Summary of Contents for NI cRIO-9074XT
Page 1: ...cRIO 9074...
