Using the RESET Button
Pressing the RESET button resets the processor in the same manner as cycling power.
Note
The FPGA continues to run unless you select the
Autoload on Any Device
Reset
boot option. Refer to the
section for more information.
Understanding LED Indications
Figure 14.
cRIO-9074XT LEDs
POWER
FPGA
STATUS
USER1
POWER LED
The POWER LED is lit while the cRIO-9074XT is powered on. This LED indicates that the
power supply connected to the chassis is adequate.
FPGA LED
You can use the FPGA LED to help debug your application or easily retrieve application
status. Use the LabVIEW FPGA Module and NI-RIO software to define the FPGA LED to
meet the needs of your application. Refer to
LabVIEW Help
for information about
programming this LED.
STATUS LED
The STATUS LED is off during normal operation. The cRIO-9074XT indicates specific error
conditions by flashing the STATUS LED a certain number of times every few seconds, as
shown in the following table
Number of
Flashes Every
Few Seconds
Indication
1
The chassis is unconfigured. Use MAX to configure the chassis. Refer
to the
Measurement & Automation Explorer Help
for information about
configuring the chassis.
2
The chassis has detected an error in its software. This usually occurs
when an attempt to upgrade the software is interrupted. Reinstall
software on the chassis. Refer to the
Measurement & Automation
Explorer Help
for information about installing software on the chassis.
NI cRIO-9074XT User Manual and Specifications
|
© National Instruments
|
15
Summary of Contents for NI cRIO-9074XT
Page 1: ...cRIO 9074...
