cRIO-9118
+5 V DC
500 mW maximum
+3.3 V DC
5,400 mW maximum
Total chassis power
consumption
5,900 mW maximum
Installing the Controller on the Chassis
Complete the following steps to install the controller on the chassis.
1.
Make sure that no power is connected to the controller or the chassis.
2.
Align the controller with the chassis.
3.
Slide the controller onto the controller slot on the chassis. Press firmly to ensure the
chassis connector and the controller connector are mated.
4.
Using a number 2 Phillips screwdriver, tighten the two captive screws on the front of the
controller to 1.3 N · m (11.5 lb · in.) of torque.
Installing C Series Modules
Verify that power is not connected to the I/O connector(s) on the C Series module.
Removing C Series Modules
Verify that power is not connected to the I/O connector(s) on the C Series module before you
remove a module from the chassis.
Product Certifications and Declarations
To obtain product certifications and the DoC for NI products, visit
, search by model number, and click the appropriate link.
Worldwide Support and Services
NI corporate headquarters is located at 11500 North Mopac Expressway, Austin, Texas,
78759-3504, USA.
4
|
ni.com
|
cRIO-9111/9112/9113/9114/9116/9118
