©
National Instruments Corporation
5
Getting Started with the NI EVS-1463
Refer to Figure 1 while completing the following steps to install the NI EVS-1463.
Figure 1.
NI EVS-1463 Connectors
1.
Connect a USB keyboard and USB mouse to any available USB connector.
2.
Connect a DVI monitor to the DVI connector, or use the DVI splitter cable (supplied) to connect a
VGA monitor or dual monitors. For independent displays in dual monitor mode, one monitor must
support a DVI-D interface and the other must support a VGA analog interface.
Note
Connect all monitors before you supply power to the NI EVS-1463.
3.
If you want to connect the NI EVS-1463 to a network, use an Ethernet cable to connect the Ethernet
hub to the primary network connector on the NI EVS-1463.
Caution
To prevent data loss and to maintain the integrity of your Ethernet installation, do
not
use
a cable longer than 100 m. If you are using a 1,000 Mbps Ethernet, use a CAT 5e or CAT 6 shielded
twisted-pair Ethernet cable. Use a shielded twisted pair Ethernet cable for maximum signal integrity.
4.
Connect devices to other connectors as required by your system configuration.
1
Primary Network Connector
2
Secondary Network Connector
3
Reset Switch
4
Audio In Connector
5
Audio Out Connector
6
Safe Mode/IP Reset/No App/
User 1/CF Master/Slave Switches
7
User 2/User 1/HDD/Power LEDs
8
CompactFlash Slot
9
Power Supply Connector
10 Grounding Lug
11 DVI-I Connector
12 MDR 26-Pin Connector
13 RS-232 Serial Connector (COM1)
14 MXI Express x1 Connector
15 15-Pin D-SUB I/O Connector
16 USB Connectors
RESET
MXIex1
COMPACT FLASH
INPUT
10-20V
90W MAX
USER 2
USER 1
HDD
POWER
CF MS/SL
SAFE MODE
IP
RESET
NO APP
USER 1
1
2
3
7
8
9
11
14 1
3
16
6
5
15
12
10
TRIGGERS
CAMERA LINK
!
4
