©
National Instruments Corporation
11
NI PXI-5660 Getting Started Guide
Figure 4.
RFSA Demo Panel Performing ACP Measurement
To use the RFSA Demo Panel, configure the following controls:
1.
Verify that the device numbers in the RFSADeviceNumbers dialog box reflect those assigned to
the RF vector signal analyzer hardware modules in MAX, and click
OK
.
2.
Specify hardware parameters for your measurement, including the following parameters, in
Hardware Settings
:
•
RF Spectrum Settings
•
Amplitude
•
Timing
•
Advanced Spectral Parameters
•
Devices
1
Measurements Controls
2
Hardware Settings Controls
3
Averaging Controls
4
Units Controls
5
Waveform Graph
1
2
5
3
4
Summary of Contents for NI PXI-5600
Page 1: ...PXI 5600...