2
|
ni.com
|
NI PXIe-4340 and TB-4340 User Guide and Terminal Block Specifications
Electromagnetic Compatibility Guidelines
This product was tested and complies with the regulatory requirements and limits for
electromagnetic compatibility (EMC) stated in the product specifications. These requirements
and limits provide reasonable protection against harmful interference when the product is
operated in the intended operational electromagnetic environment.
This product is intended for use in industrial locations. However, harmful interference may
occur in some installations, when the product is connected to a peripheral device or test object,
or if the product is used in residential or commercial areas. To minimize interference with radio
and television reception and prevent unacceptable performance degradation, install and use this
product in strict accordance with the instructions in the product documentation.
Furthermore, any modifications to the product not expressly approved by National Instruments
could void your authority to operate it under your local regulatory rules.
Caution
To ensure the specified EMC performance, operate this product only with
shielded cables and shielded accessories. Use only twisted, shielded pair cables for
channel connections. Refer to the
NI PXIe-4340 User Manual
for specific guidance
on terminating cable shields.
Caution
To ensure the specified EMC performance, the length of all I/O cables
must be no longer than 30 m (100 ft).
What You Need to Get Started
To set up and use a PXIe-4340 module with a TB-4340 terminal block, you need the following
items:
Hardware
–
PXIe-4340 module
–
TB-4340 terminal block
