NI 9795 Getting Started Guide
12
ni.com
b. Once detected, select the NI CompactRIO chassis you
wish to use and click
OK
.
c. If you have LabVIEW FPGA installed, select
Scan
Interface
as the programming mode of the
NI CompactRIO device and click
Continue
. This
populates the LabVIEW Project window with the
NI CompactRIO chassis.
Note
The NI 9795 WSN C Series gateway can only be used
in a NI CompactRIO chassis that supports the RIO Scan
Interface (RSI). For more information, go to
ni.com/
info
and enter
rdsoftwareversion
. To use RSI and
FPGA at the same time with a NI 9795 in the CompactRIO
chassis, go to
ni.com/kb
and enter
4XRBMIUV
.
If the NI CompactRIO device is not on the local subnet,
complete the following steps:
a. Right-click the project name and select
New»Targets and
Devices
,
click
Existing target or device
, and click
Specify a target or device by IP address
.
b. Select
IP Address
and enter the IP address.
