6
|
ni.com
|
NI-XNET LIN Transceiver Cable Operating Instructions
The Transceiver Cable is intended to be routed and strain relieved
similar to other cables, and does not require a special mounting
accessory.
Wiring to the NI-XNET LIN Transceiver Cable
The NI-XNET LIN Transceiver Cable is used with a compatible
NI-XNET Transceiver Cable host port.
Figure 1.
NI-XNET LIN Transceiver Cable Connections
The NI-XNET LIN Transceiver Cable has one 9-pin male D-Sub
connector that provides connections to a LIN bus.
The port has two common pins (COM) that are internally
connected to the transceiver cable’s isolated reference and serve as
the reference ground for the LIN signal. You can connect the LIN
bus reference ground to one or both COM pins.
The D-Sub connector shell connects through the NI-XNET LIN
Transceiver Cable shielding to the connector on the host port end.
The shielding does not electrically connect to the COM signals.
To LIN B
us
To Tr
a
n
s
ceiver
C
ab
le Ho
s
t
NA
TIONAL
INSTRUMENTS
