©
National Instruments Corporation
7
NI-FBUS Installation Guide for Windows
Install Your FBUS-HSE/H1 LD
The FBUS-HSE/H1 LD has a simple rail clip for reliable mounting onto a
standard 35 mm DIN rail.
To install the FBUS-HSE/H1 LD, complete the following steps.
1.
Use a flathead screwdriver to open the DIN rail clip to the unlocked
position, as shown in Figure 5.
Figure 5.
DIN Rail Clip
2.
Hook the lip on the rear of the FBUS-HSE/H1 LD onto the top of a
35 mm DIN rail and press the FBUS-HSE/H1 LD down onto the DIN
rail, as shown in Figure 6.
Figure 6.
Mounting the FBUS-HSE/H1 LD on a DIN Rail
1
Cover
2
Lip
3
35 mm DIN R
a
il
4
Pre
ss
on to R
a
il
Rail Clip Locked
Rail Clip Unlocked
4
1
2
3
