Chapter 2
Installation and Configuration
2-8
ni.com
3.
Locate your card under the heading
National Instruments Fieldbus
Interfaces
.
4.
Click the name of the card, then click the
Properties
button.
5.
Use the
Resources
tab to view or edit the resources assigned to the
card.
(Windows NT)
Windows NT usually assigns conflict-free resources
automatically. To view assigned resources in Windows NT, complete the
following steps:
1.
Select
Start»Programs»Administrative Tools (Common)»
Windows NT Diagnostics
, and select the
Resources
tab.
2.
Click the
Devices
button.
3.
Double-click
nifb
.
4.
Make sure the settings shown match the settings configured on your
card.
5.
Click
OK
twice.
Changing or Deleting Existing Interface Information
To change or delete information about any interface that you have already
entered, complete the following steps:
1.
Select
Start»Programs»National Instruments FBUS»Interface
Config
.
2.
Click the
Board
x
icon, where
x
refers to the board number of the
interface you want to change or delete.
3.
Click the
Edit
button. You can edit the interface configuration
information that you entered earlier, or click
Delete
to delete this
interface entirely.
Interfaces are numbered beginning with zero. If you delete an interface,
the NI-FBUS Interface Configuration utility renumbers all the remaining
interfaces. For example, if you delete
Board0
, it appears that you deleted
the last interface, because all the remaining interface numbers are
decreased by one automatically.
