36
Phase Matrix PXI-1430B RF Downconverter Module
Quick Start Guide
Service Information
Periodic Maintenance
Phase Matrix recommends the PXI module be calibrated every 12
months from the time the module is initially powered on. The specific
calibration interval depends on the accuracy required by the end user's
application. Accuracy of the module is not affected by non-operation
when the module is properly stored in its original packaging or
equivalent.
PXI Module Identification
Each PXI module is identified by three sets of numbers: the model
number (PXI-1450 is shown in this example), a configuration-control
number (CCN), and a serial number (S/N).
These numbers are located on a label affixed to the frame on the side of
the PXI-1430B (some units may have separate CCN and serial-number
labels). The model number, CCN, serial number, and the numbers of any
options must be included in any correspondence regarding your
PXI module. A typical serial-number label is shown in
Figure 17
Example of a Label Affixed to the Side of the PXI Module
Factory Service
If you are returning a PXI module to Phase Matrix for service or repair,
be sure to include the following information with the shipment:
•
Name and address of owner.
•
Model, complete serial number, and CCN of the PXI module.
•
A complete description of the problem. Be sure to provide enough
information so that the problem can be verified:
•
Under what conditions did the problem occur?
•
Did the unit work and then fail?
•
What other equipment was connected to the PXI module when
the problem occurred?
•
The name and telephone number of someone familiar with the
problem who can be contacted by Phase Matrix if any further
information is required.
•
The shipping address to which the PXI module is to be returned.
Include any special shipping instructions.
Model Number
Configuration Control Number
Serial Number
