PXI-1000B AC Power Supply Shuttle Installation Guide
10
ni.com
Exterior Cleaning
Clean the exterior surfaces of the power supply shuttle with a dry lint-free
cloth or a soft-bristle brush. If any dirt remains, wipe with a cloth moistened
in a mild soap solution. Remove any soap residue by wiping with a cloth
moistened with clear water. Do not use abrasive compounds on any part of
the power supply shuttle.
Caution
Avoid getting moisture inside the power supply shuttle during exterior cleaning.
Use just enough moisture to dampen the cloth.
Do
not
wash the rear-panel connectors or switches. Cover these components while cleaning
the power supply shuttle.
Do
not
use chemical cleaning agents; they may damage the power supply shuttle. Avoid
chemicals that contain benzene, toluene, xylene, acetone, or similar solvents.
Cleaning the Fan Filters
You can easily remove the cooling filters from the rear of the power supply
shuttle by removing the plastic housing attached to each fan.
Clean the fan filters by washing them in a mild soap solution and then
drying them by vacuuming or blowing air through them. Rinse the filters
with water and allow them to dry before reinstalling them on the power
supply shuttle.
