Chapter 2
Installation and Configuration
©
National Instruments Corporation
2-5
NI PXI-1031/PXI-1031DC User Manual
Connecting to an AC Power Source
Attach input power through the rear AC inlet using the appropriate
AC power cable supplied. Refer to Figure 1-2,
Rear View of the PXI-1031
Chassis
, or to Figure 1-3,
Rear View of the PXI-1031DC Chassis
, to locate
the AC inlet.
The power switch allows you to power on the chassis or place it in standby
mode. Press the power switch to the On position (if not already on).
Observe that all fans become operational.
Connecting to a DC Power Source (PXI-1031DC Only)
For full chassis power, the DC source must be capable of providing
a minimum of 300 watts of continuous power per feed pair to the
P1 connector on the PXI-1031DC power supply.
DC Connector
Figure 2-2 shows the DC connector (P1) that appears on the rear panel of
the PXI-1031DC power supply.
Figure 2-2.
The P1 DC Input Connector
Table 2-1.
DC Power Requirements
Electrical Element
Requirement
Voltage
18–30 VDC
DC Input Current
30–10 A
P1
Po
s
itive
(+)
Neg
a
tive
(–)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
