Table 2.
NI 5610 RF Upconverter Module Front Panel Connectors
Connector
Use
TO AWG CLK IN
Connects to the CLK IN connector on the NI 5441 AWG module
front panel.
Both connectors are output terminals for replications of the
upconverter 10 MHz frequency reference signal, which is useful for
driving other devices. Each replication is 180° out of phase with the
other. The output signal at these connectors is always on and cannot
be disabled.
10 MHz OUT
REF IN
Routes an external frequency reference signal that can be propagated
to the PXI backplane. The NI 5610 can lock to this signal.
INPUT
Connects to the CH 0 output on the NI 5441 AWG module front
panel.
Routes the IF signal from the NI 5441 AWG module for frequency
translation.
LOCAL OSC OUT 0 Routes the auxiliary local oscillator signal.
RF OUTPUT
Routes the upconverted signal at the requested RF frequency.
NI PXI-5671 Getting Started Guide
|
© National Instruments
|
11
