©
National Instruments Corporation
2-1
2
Installation and Configuration
This chapter describes how to prepare and operate the NI PXIe-1065
chassis.
Before connecting the chassis to a power source, read this chapter and
the
Read Me First: Safety and Radio-Frequency Interference
document
included with your kit.
Safety Information
Caution
Before undertaking any troubleshooting, maintenance, or exploratory procedure,
carefully read the following caution notices.
This equipment contains voltage hazardous to human life and safety, and
is capable of inflicting personal injury.
•
Chassis Grounding
—The chassis requires a connection from the
premise wire safety ground to the chassis ground. The earth safety
ground must be connected during use of this equipment to minimize
shock hazards. Refer to the
section for
instructions on connecting safety ground.
•
Live Circuits
—Operating personnel and service personnel
must
not
remove protective covers when operating or servicing the chassis.
Adjustments and service to internal components must be undertaken
by qualified service technicians. During service of this product,
the mains connector to the premise wiring must be disconnected.
Dangerous voltages may be present under certain conditions;
use extreme caution.
•
Explosive Atmosphere
—Do
not
operate the chassis in conditions
where flammable gases are present. Under such conditions, this
equipment is unsafe and may ignite the gases or gas fumes.
