Chapter 2
Installation and Configuration
©
National Instruments Corporation
2-15
Complete the following steps to reserve these trigger lines in MAX.
1.
In the Configuration tree, click on the PXI chassis branch you want to
configure.
2.
Then, in the right-hand pane, toward the bottom, click on the
Triggers
tab.
3.
Select which trigger lines you would like to statically reserve.
4.
Click the
Apply
button.
PXI Trigger Bus Routing
Some National Instruments chassis, such as the PXI-1065 and the
PXI-1044/1045, have the capability to route triggers from one bus to others
within the same chassis using the
Trigger Routing
tab in MAX, as shown
in Figure 2-6.
Note
Selecting any non-disabled routing automatically reserves the line in all trigger
buses being routed to. If you are using NI-DAQmx, it will reserve and route trigger lines
for you, so you won’t have to route trigger lines manually.
Complete the following steps to configure trigger routings in MAX.
1.
In the
Configuration
tree, select the chassis in which you want to
route trigger lines.
2.
In the right-hand pane, select the
Trigger Routing
tab near the bottom.
3.
For each trigger line, select
Route Right
,
Route Outward From
Middle
, or
Route Left
to route triggers on that line in the described
direction, or select
Disabled
for the default behavior with no manual
routing.
4.
Click the
Apply
button.
