5/9
www.ni.com
50 mV
pp
Over- current protection
All outputs protected from short circuit and overload with automatic recovery
Over- voltage protection
3.3 V and 5 V
Clamped at 20 to 30% above nominal output voltage
Power supply shuttle MTTR
Replacement in under 5 minutes
Chassis Cooling
Module cooling system
NI PXIe- 1065
Forced air circulation (positive pressurization) through three 165 cfm fans with
High/Auto speed selector
Slot airflow direction
Bottom of module to top of module
Module cooling intake
Bottom rear of chassis
Module cooling exhaust
Along both sides and top of chassis
Power supply cooling system
Forced air circulation through two integrated fans
Power supply cooling intake
Right side of chassis
Power supply cooling exhaust
Left side of chassis
Environmental
Maximum altitude
2,000 m (800 mbar) (at 25 ° C ambient)
Pollution Degree
2
For indoor use only.
Operating Environment
Ambient temperature range
0 to 55 ° C (Tested in accordance with IEC- 60068-2- 1 and IEC- 60068-2- 2.
Meets MIL-PRF- 28800F Class 3 low temperature limit and MIL- PRF- 28800F
Class 2 high temperature limit.)
Relative humidity range
10 to 90%, noncondensing (Tested in accordance with IEC- 60068-2- 56.)
Storage Environment
Ambient temperature range
– 40 to 71 °C (Tested in accordance with IEC- 60068-2- 1 and IEC- 60068-2-
2. Meets MIL-PRF- 28800F Class 3 limits.)
Relative humidity range
5 to 95%, noncondensing (Tested in accordance with IEC- 60068-2- 56.)
Shock and Vibration
Operational shock
30 g peak, half- sine, 11 ms pulse (Tested in accordance with IEC- 60068-2-
27. Meets MIL-PRF- 28800F Class 2 limits.)
Random Vibration
5 to 500 Hz, 0.3 g
rms
Acoustic Emissions
Sound Pressure Level (at Operator Position)
(Tested in accordance with ISO 7779. Meets MIL-PRF- 28800F requirements.)
Auto fan (up to ~30 °C ambient)
45.0 dBA
High fan
63.3 dBA
Sound Power
Auto fan (up to ~30 °C ambient)
55.5 dBA
High fan
76.2 dBA
Note Specifications are subject to change without notice.
Safety Standards
This product is designed to meet the requirements of the following standards of safety for electrical equipment for measurement, control, and laboratory use:
IEC 61010-1, EN 61010- 1
UL 61010- 1, CSA 61010-1
Note For UL and other safety certifications, refer to the product label or the
section.
Online Product Certification
Electromagnetic Compatibility