Figure 10. Installing a PXI Express System Controller
COOLING CLEARANCE REQ
UIRED. SEE MANUAL.
4
3
2
1
1. System Controller Front Panel Mounting Screws
(4x)
2. PXI Express System Controller
3. Injector/Ejector Handle
4. PXI Express Chassis
3.
When you begin to feel resistance, pull up on the injector/ejector handle to seat the
system controller fully into the chassis frame. Secure the system controller front panel to
the chassis using the system controller front panel mounting screws.
4.
Connect the keyboard, mouse, and monitor to the appropriate connectors. Connect
devices to ports as required by your system configuration.
5.
Power on the chassis. Verify that the system controller boots. If the system controller does
not boot, refer to the
Troubleshooting
section or your system controller user manual.
Installing Peripheral Modules
Caution
The PXIe-1092 chassis has been designed to accept a variety of
peripheral module types in different slots. To prevent damage to the chassis, ensure
that the peripheral module is being installed into a slot designed to accept it.
Note
Refer to your module user manual for specific instructions and warnings.
This section contains general installation instructions for installing a peripheral module in a
PXIe-1092 chassis. To install a module, complete the following steps:
1.
Connect the AC power source to the PXI Express chassis before installing the module.
The AC power cord grounds the chassis and protects it from electrical damage while you
install the module.
PXIe-1092 User Guide
|
© National Instruments
|
19
