PXIe-4844 Installation Guide and Specifications
|
© National Instruments
|
3
What You Need to Get Started
LabVIEW 2009 (32-bit), 2010 (32-bit), 2011 (32-bit), 2012 (32-bit), 2013 (32-bit),
2014 (32-bit), 2015 (32-bit), or 2016 (32-bit)
PXI Express chassis with
–
controller,
or
–
MXI-Express (card or built-in)
FBG sensors
Multiplexer for additional channels (optional)
Installing the NI-OSI Driver Software
Install the NI-OSI driver software on the host computer
before
installing the PXIe-4844 module.
Refer to
readme_OSI.html
, located in the
National Instruments\OSI Explorer
directory, for software installation instructions, LabVIEW compatibility information, and
system requirements.
Installing the PXIe-4844
This section contains installation instructions for the PXIe-4844. Refer to your PXI Express
chassis user manual for chassis instructions and warnings.
1. Plug in your chassis before installing the PXIe-4844. The power cord grounds the chassis
and protects it from electrical damage while you install the module.
2. Make sure the chassis power switch is turned off.
Caution
To protect both yourself and the chassis from electrical hazards, leave the
chassis powered off until you finish installing the PXIe-4844 module.
3. Touch a metal part on the chassis to discharge any static electricity that might be on your
clothes or body.