Users Guide
QuickSyn Lite Frequency Synthesizer
37 of 40
ni-microwavecomponents.com
The Create List dialog box, shown in Figure 42, is accessible by
selecting the Create New List button in the Edit List dialog box.
The entry boxes on the Edit List dialog box are automatically
populated when the entry boxes within the Create List dialog box
are filled and the Create List button is selected.
Begin Frequency, End Frequency
These entry boxes are used
to specify the initial and final frequency values the list will start and
end with. To enter values, highlight the number in the entry box and
enter a value or use the up/down arrow on the left side of the box.
Dwell Time
This entry box is used to specify the dwell time for
all points on the list. To enter values, highlight the number in the
entry box and enter a value or use the up/down arrow on the left side
of the box.
Number of Points
The number of points to be included in the
list is entered in the Number of Points entry box. To enter values,
highlight the number in the entry box and enter a value or use the up/
down arrow on the left side of the box.
RF Output
The RF Output button, when pressed, disables RF
output at each point on the list. The button is illuminated when on.
Create List
Selecting the Create List button executes the action of
populating the entry boxes in the Edit List dialog box.
Cancel
The Cancel button in the Create List dialog box, closes the
dialog box and does not save the values entered in the entry boxes.
Step 5-6 Review the Create List Dialog Box
Figure 42
Create List Dialog Box
