background image

RMX-10050/10051 User Guide

|

© National Instruments

|

3

When the DC output feature is included, it draws power from the AC mains, and affects the 
available AC Output power. DC output ratings are shown in the following table.

Note

All models, except the RMX-10050 (785342-01), include a DC output 

feature. The total DC Output is always limited to 500 W. This is divided evenly as 
125 W per each of the four output channels. 

Safety

This product is intended for indoor use only and should not be exposed to excess moisture.

This product is intended for installation in a restricted access location by a skilled person.

This product is intended for use by an instructed person.

This product is classified as pluggable equipment. The mains inlet plug serves as the
disconnect device. The mains inlet plug shall be installed so that it is easily accessible.

This product is equipped with a safety ground connection through the mains inlet plug,
as well as a redundant chassis ground screw on the rear panel. Ensure that the product is
properly grounded before applying power.

Disconnect all power to the product prior to servicing.

Do no open this product as it contains no user serviceable parts inside. All service concerns 
should be directed to National Instruments.

The ratings for all output receptacles are marked on the top cover of the chassis. Be sure to 
observe the ratings for all connected load equipment.

If this product is used in a manner which does not comply with this instruction manual,
the protection provided by the equipment may be impaired.

Hot Surface

Contact with the top cover of chassis may cause burns. Ensure the 

unit has cooled prior to handling.

Table 4.  

RMX-10050/10051 Family DC Output Ratings

DC 

Channel

Power 

Capacity

Voltage

RMX-10050

(785341-01)

Output 

Rating

RMX-10051

(785344-01)

Output 

Rating

RMX-10051

(785343-01) 

Output 

Rating

DC1 

125 W

12 VDC

10.4 A max

12.5 A max

12.5 A max

DC2

125 W

24 VDC

5.2 A max

6.25 A max

6.25 A max

DC3

125 W

24 VDC

5.2 A max

6.25 A max

6.25 A max

DC4

125 W

48 VDC

2.6 A max

3.13 A max

3.13 A max

Summary of Contents for RMX-10051











Reviews: