18
|
ni.com
|
RMX-8268 Installation Guide
Reconfiguring the RMX-8268 to Its Default State
To reconfigure your RMX-8268 to its default state of RAID0, complete the following steps.
These instructions use the MegaRAID Storage Manager browser-based RAID management
console. Refer to the RAID controller user manual at
ni.com
for more information about using
this software.
1.
Open the MegaRAID Storage Manager.
2.
Enter the PXI Express Host
User Name
and
Password
(use your Windows username and
password).
3.
Under the
Logical
tab, right-click
Controller0
and select
Create Virtual Drive
.
4.
Select
Advance
and click
Next
.
5.
Select RAID0 from the
RAID Level
pull-down menu.
6.
Select all drives (<CTRL-A>).
7.
Click
ADD
and then
Next
.
8.
Make the following changes on the Virtual Drive properties page and leave everything else
at default:
•
Stripe Size (KB)
—512 KB
•
Write cache
—Write Through
9.
Select
Create Virtual Drive
.
10. Click
OK
at the warning about Write Through Mode.
11. Select
Finish
.
Follow the instructions in this guide under the
section to configure
your new virtual disk for use with your Windows operating system.
