•
Wire insulation stripper
•
Wire cutters
•
Strain relief assembly for the Nano-Pitch cable
Note
The strain relief assembly ships with Molex Nano-Pitch cables
purchased from NI. To ensure an uninterrupted connection, NI recommends,
but does not require, use of the strain relief assembly.
•
NI 9913 DIN rail mounting kit (NI part number 781740-01)
Preparing the FlexRIO Module
1.
Install and configure the FlexRIO module you want to connect to the SCB-12.
Note
For installation and configuration instructions, refer to the
Getting
Started Guide
for your product, accessible at
2.
Connect the Molex
™
Nano-Pitch I/O
™
cable to your FlexRIO module.
Note
For DIO signal specifications, refer to the specifications document for
the FlexRIO module you want to connect to the SCB-12. Search for
specification documents by product name at
Connecting to the SCB-12
The SCB-12 enables access to DIO signals from a Molex
™
Nano-Pitch I/O
™
cable through
other common connectors. To use the SCB-12, you must first connect a Molex
™
Nano-Pitch
I/O
™
cable to your FlexRIO module.
Figure 2. SCB-12 Front Panel
DIO 5DIO 6DIO 7GND
DIO 2
DIO 3
DIO 4
5V A
UX
SCB-12
Aux I/O Breakout Accessory
PORT 0
POWER
DIO 0/
MGT REF CLK+
DIO 1/
MGT REF CLK–
DIO
Connecting to the Molex
™
Nano-Pitch I/O
™
DIO Port
1.
Connect the Molex
™
Nano-Pitch I/O
™
cable to the port labeled DIO.
Notice
Using signal voltages outside of the range specified for the FlexRIO
module you connect to the SCB-12 could damage the SCB-12 and any
instruments connected to it. For maximum voltage specifications, refer to the
documentation for the connected hardware. NI is not liable for any damage
resulting from using voltages outside of the recommended range.
6
|
ni.com
|
SCB-12 User Guide
