2
¥ Replacement bracket for NB-MIO-16 boards
¥ Two cable tie wraps
¥
SCXI-1345 Shielded Cable Installation Guide
If your kit is missing any of the components, contact National Instruments.
Installation Procedure
Figure 1 illustrates the components of your SCXI system and how to connect them.
SCXI Module
Adapter
Board
Step 3
Step 4
Step 7
Shielded Cable
Grounding Strap
Step 8
Step 9
MIO Data Acquisition Board
Figure 1. Connecting the SCXI-1345 to Your MIO Board and SCXI Module
Perform the following steps to install the SCXI-1345 cable:
1. Turn off the power to your computer and the SCXI chassis.
2. Install your SCXI module in the SCXI chassis, following the instructions in your module
user manual.
3. Plug the socket connector of the SCXI-1345 adapter board into the rear signal connector of
the SCXI module.
4. Secure the SCXI-1345 adapter board by screwing the two screws through the rear panel of
the adapter board and into the threaded strips in the rear of the SCXI chassis.