SCXI-1383 Power Supply/Float Charger
6
ni.com
Figure 2.
Charging the SCXI-1382 Battery Pack with the SCXI-1383 Charger
Connecting the SCXI-1383 to the SCXI-1000DC Chassis
and the SCXI-1382 Battery Pack in Float-Charging Mode
Caution
Always power off the SCXI-1000DC and unplug the SCXI-1383 before you
connect or disconnect them from each other or the SCXI-1382.
To connect the SCXI-1383 power supply/float charger to the
SCXI-1000DC and the SCXI-1382 battery pack in float-charging mode,
refer to Figure 3 and complete the following steps:
1.
Fully charge the battery, as described in the
Battery Pack with the SCXI-1383
section
,
before connecting the
SCXI-1383 to the SCXI-1382 battery pack in float mode.
2.
Power off the SCXI-1000DC chassis using the power switch on the
SCXI-1000DC front panel.
3.
Connect the green DC power connector (P1) on the SCXI-1382 battery
pack to its corresponding connector (J1) on the rear panel of the
SCXI-1000DC chassis.
4.
Connect the green DC power connector (P2) of the SCXI-1383 power
supply/float charger to its corresponding connector (J2) on the rear
panel of the SCXI-1382 battery pack.
1
J2
2
SCXI-1382 Battery Pack
3
P2
4
SCXI-1383 Power Supply/Float Charger
5
To VAC Power Source
2
1
4
5
3
