©
National Instruments Corporation
17
DIN160 Cable Installation Instructions
SH160DIN-BARE WIRE Cable
The SH160DIN-BARE WIRE cable is recommended for connecting the switch module to your system
if termination other than a 50-pin female D-SUB or a DIN160 connector is required. One end of the
cable terminates with a DIN160 connector. The other end of the cable has six bundles of unterminated,
tinned, and stripped wires.
Use the pinouts and the pin assignments listed in Tables 5 through 10 to determine how to connect
signals to your application.
Note
The first color listed in the Bare Wire Color column of Tables 5 through 10 is the primary
color of the wire. The second color listed is the stripe color.
E4
CH66
E5
DUT66
E2
CH67
E3
DUT67
E10
USER_2
*
E1
RESERVED
†
*
USER_
n
signals are not used by the NI PXI-2510.
†
RESERVED signal is reserved by the NI PXI-2510 for future use.
Table 4.
Pin Assignment for SH160DIN-160DIN Cable (Continued)
160DIN Mating Connector
160 DIN P1/P2 Pin
NI PXI-2510 Channel
