10
|
ni.com
|
SLSC-12001 Chassis Getting Started Guide and Specifications
2.
Ensure that any alternate power source(s) connected the RTI(s) or modules are powered off.
3.
Inspect the slot pins on the chassis backplane for any bending or damage prior to installing
a module.
4.
Install a module into a chassis slot by first placing the module PCB into the front of the PCB
guides at the top and bottom.
5.
Slide the module into the chassis until you begin to feel resistance then push up the
injector/ejector handle to fully seat the module into the chassis frame.
6.
Secure the module front panel to the chassis using the module front-panel mounting screws.
Figure 6.
SLSC-12001 Module Installation
Removing SLSC Modules
Caution
The SLSC-12001 chassis and the SLSC modules do not support hot
plug-in. The entire chassis must be powered down when a module is removed.
Complete the following steps to remove an SLSC module from the chassis:
1.
Power off the main DC power source or disconnect it from the chassis before removing the
module.
2.
Ensure that the chassis is powered off. The POWER LED should be off. If it is not off,
do not proceed until the POWER LED is off.
3.
Ensure that any alternate power source(s) connected the RTI(s) are powered off.
1
Module
2
Injector/Ejector Handle
SLS
C-12
001
SW
ITC
H/L
OAD
/SIG
NA
L C
ON
D.
DO
NO
T IN
SER
T O
R R
EMO
VE
MO
DU
LES
WH
ILE
PO
WE
RED
POW
ER
AC
TIV
ITY
STA
TUS
SLS
C-12
001
SW
ITC
H/L
OAD
/SIG
NA
L C
ON
D.
DO
NO
T IN
SER
T O
R R
EMO
VE
MO
DU
LES
WH
ILE
PO
WE
RED
POW
ER
AC
TIV
ITY
STA
TUS
2
1
