varies when multiple devices stream through the same controller. Consider using an NI 294x
or NI 295x device if you need to build a high-channel count system.
Configuring NI 2900/2901 Devices
Confirming USB Connection
1.
Select
Start
»
All Programs
»
National Instruments
»
NI-USRP
»
NI-USRP
Configuration Utility
to open the NI-USRP Configuration Utility.
2.
Select the
Devices
tab of the utility.
Your device should appear in the list on the left side of the tab, similar to the following
figure.
Figure 1.
Confirming USB Connection
Note
If your device is not listed, verify that your device is powered on and
correctly connected, then click the Refresh Devices List button to scan for NI
USRP devices.
Changing the Device ID
To change the NI 2900/2901 device ID, you must know the current address of the device.
1.
Verify that your device is powered on and connected to your computer using the USB 3.0
or 2.0 interface.
2.
Select
Start
»
All Programs
»
National Instruments
»
NI-USRP
»
NI-USRP
Configuration Utility
to open the NI-USRP Configuration Utility.
6
|
ni.com
|
NI USRP-2900/2901 Getting Started Guide
