Back Panel
0
1
PWR
REF
IN
PPS
OUT
TRIG
5V DC
REF
OUT
1G/10G ETH
3.3 V
+15 dBm
MAX
9-16V DC
7.5 A MAX
SFP+Ports
PCIe x4
TRIG
3.3V
IN
5V MAX
PPS
GPS
ANT
–15 dBm
MAX
Connector
Use
PWR
Input that accepts a 9 V to 16 V, 6 A external DC power connector.
1G/10G ETH Two SFP+ input terminals used for 1G ETH or 10G ETH connectivity with the host
driver. Not currently supported in LabVIEW FPGA.
REF OUT
Output terminal for an external reference signal for the LO on the device. REF OUT
is a female SMA connector with an impedance of 50 Ω, and it is a single-ended
reference output. The output signal at this connector is 10 MHz at 3.3 V.
REF IN
Input terminal for an external reference signal for the LO on the device. REF IN is a
female SMA connector with an impedance of 50 Ω, and it is a single-ended
reference input. REF IN accepts a 10 MHz signal with a minimum input power of
0 dBm (0.632 Vpk-pk) and a maximum input power of 15 dBm (3.56 Vpk-pk) for a
square wave or sine wave.
PCIe x4
Port for a PCI Express Generation 1, x4 bus connection through an MXI Express
four-lane cable.
PPS TRIG
OUT
Output terminal for the pulse per second (PPS) timing reference. PPS TRIG OUT is
a female SMA connector with an impedance of 50 Ω, and it is a single-ended input.
The output signal is 0 V to 3.3 V TTL. You can also use this port as triggered output
(TRIG OUT) that you program with the PPS Trig Out I/O signal.
PPS TRIG IN Input terminal for pulse per second (PPS) timing reference. PPS TRIG IN is a female
SMA connector with an impedance of 50 Ω, and it is a single-ended input channel.
PPS TRIG IN accepts 0 V to 3.3 V TTL and 0 V to 5 V TTL signals. You can also use
this port as a triggered input (TRIG IN) that you control using NI-USRP software.
GPS ANT
Input terminal for the GPS antenna signal. GPS ANT is a female SMA connector
with a maximum input power of -15 dBm and an output of DC 5 V to power an
active antenna.
Notice
Do not terminate the GPS ANT port if you do not use it.
Table 13. Connector Descriptions
© National Instruments
31
USRP-2940/2942/2943/2944/2945 Getting Started
