Chapter 7
VirtualBench-Power Supply
© National Instruments Corporation
7-5
Getting Started with VirtualBench
Complete these steps to generate an AC power signal:
1.
Click the Volts AC button to select AC volts mode, as shown in
Figure 7-4.
Figure 7-4. Front Panel with Volts AC Button Selected
2.
Enter the appropriate settings for your AC signal.
3.
Click Apply to commit to the change. If a red error button appears in
the display window, click the button to display the cause of the error.
Adjust the settings if necessary.
4.
Click Output to enable the power supply.
To exit VirtualBench-Power Supply, select File»Exit. VirtualBench-Power
Supply saves your current settings for the next session.
