©
National Instruments Corporation
A-1
A
Default Settings
This appendix summarizes the default settings for the hardware and
software in your kit. If you need more information about a particular
setting, or if you want to try a different configuration, please refer to
the appropriate VXIpc user manual for your hardware reference and
to Chapter 3,
, for your software reference.
Because you can also use vxitedit to configure a VXI-MXI-2 or a
VME-MXI-2, this appendix also summarizes the software default settings
for the VXI/VME-MXI-2.
VXIpc Controller
This section summarizes the hardware and software default settings for the
VXIpc controllers.
Table A-1.
VXIpc 770/870B Series Hardware Default Settings
Jumper
Default Setting
Optional Setting
W5
1–2 Normal CMOS operation
2–3 Clear CMOS
W6
2–3 16-bit SCSI termination enabled
1–2 SCSI termination disabled
J20
No jumper
Master/Slave/CSEL*
J17
3–4 Automatic slot zero detection
1–2 Non-slot 0
5–6 Force slot 0
W2
2–3 Enable MITE self-configuration
1–2 Disable MITE self-configuration
W1
2–3 MITE user configuration
1–2 MITE factory configuration
S1
1–2 Internal oscillator
2–3 External oscillator
* These pins are generally defined in a figure on the hard drive cover.
