Remote monitor operation
13
If SOLAR or DC is the active charge source, the displayed voltage
represents the voltage of that source.
Display mode 1
- This mode focuses on the auxiliary battery with the
majority of the screen used to show the auxiliary battery voltage and
If there are no active charge cycles, “STBY” is displayed.
The input source (ALT, SOLAR or DC) as well as charge current is
displayed during a charge cycle.
battery temperature.
The display will turn off automatically after a short delay if there is no active charge cycle.
The remote monitor can be turned ON or OFF by pressing the
POWER
button.
The display brightness can be increased or decreased by pressing the
UP
or
DOWN
buttons.
If there is no active charge cycle, “STANDBY” is displayed.
During a charge cycle, the input source (ALT, SOLAR or DC) is displayed
with the actual charge current.
Display mode 2
- In this mode, the status of the main and auxiliary
batteries are represented as graphical bar-graphs.
The actual voltages are shown for the respective batteries.
If there are no active charge cycles, “STBY” is displayed.
Display mode 3
- This mode shows voltages of the respective main and
auxiliary batteries as well as charger mode, charge current, battery type
and battery temperature.
The remote monitor has 3 display modes that represent the status of the charging system in different
ways.
Press the
MODE
button to cycle through the different display options.