8
Installing Battery
It is best to lay the Power Pack on its side or end to do this.
To hold a battery securely in the Power Pack, install the U-bolt and hold-down bracket.
Note : Select the battery type before installing the auxiliary battery.
See page 7.
Return the Power Pack to the
upright position.
Insert the U-bolt through the holes
drilled into the bottom of the
Power Pack.
Remove the Power Pack sliding lid
and insert the auxiliary battery into
the battery compartment.
Attach the hold-down bracket,
washers and wing-nuts.
Connect the positive (RED) and
negative (BLACK) cables to the
battery terminals.
Make sure the connections are
clean and tight
Take care not to over-tighten the
screws.
1
2
3