7
CHANGING THE GUIDE
Depress the thumb release
button.
Pull the guide free from tool.
Insert new guide paying attention
to the direction of the alignment
tabs.
Always remove the collation strip before removing the guide.
LOADING SCREW STRIPS
Be sure that you have the correct bit size inserted for the fastener that you are driving! The CAMO
®
DRIVE
™
has both necessary
bit sizes include in the package.
Edge: T15 Clip: T15 Face: T20
Insertion end of screw strip has
arrows
Hold body of the tool with one
hand so that screws stay in place
Slide strip into screw strip channel
Slide picker up to nose of the tool
and fold the open strip onto the
picker teeth with your pointer
finger
Slide collation strip up and
through the nose of the tool until
it will go no further
Caution! Be very careful not to let
go of the picker as it will recoil
very quickly and could damage
the tool when it strikes the stop.
Make sure the strip is firmly
hooked to the picker teeth.
Summary of Contents for CAMO DECK RESPONSIBLY DRIVE
Page 14: ...14 ...
