ASSEMBLY :
STEP 1) Ascertain that there are NO missing or dam-
aged parts.
STEP 2) While holding up one side of the “T” side-bar
(Part A), bolt crossbeam (Part C) into the middle set of
holes. NOTE: This set of holes has three holes. Use ei-
ther the two lower or two higher ones for installation.
STEP 3) Take the other side “T’ bar (Part A), and bolt it
to crossbeam (Part C) in the middle set of holes.
STEP 4) Take one EXT-8 bar (Part E) and place the wid-
er part over the top of the “T” bar (Part A). Align the
two holes of the EXT-8 bar with the holes of the “T”
bar and bolt them in.
STEP 5) Take the other EXT-8 bar (Part E) and do the
same to the other “T” bar.
STEP 6) Take the Chair rack (Part B), and bolt it to the
set of holes on top of the EXT-8 bar.
STEP 7) Finally, bolt other crossbeam (Part C), into the
bottom sets of holes on both “T” side-bars (Parts A).
STEP 8) Ascertain that each and every nut and bolt is
securely tightened to its maximum!
STEP 9) Load up folding chairs on chair rack. Then load
up to six tables on each side of the bottom of unit. Once loaded,
secure tables using both of the provided bungee cords. Start by
inserting one end of the cord into holes located on steel table
holders (Part D) at bottom of unit then pulling around over ta-
bles and inserting second end of cord into holes on the corre-
sponding steel table holders.
OPTIONAL STEP 8) Attach optional coat rods to the chair hang-
ing rods (on parts B), use as coat rack when chairs are out.
* The EXT-8 Extender bar should be used to accommodate the
following NPS chairs: 3200 series, 1100 series and 600 series
Model # 42-8 Table/Chair Storage Truck
Assembling unit with Optional EXT-8 Extender
bar*
If you experience any problems with this product,
please call our customer service department at 800-261-4112
