SMA2RJ45EVK User Manual
Board Description
Figure 2 shows the adapter board drawing with the silkscreen annotations. The 1.75 by 1.0 inch,
four-layer PCB is designed to bring RJ45 connector signal pins to SMA connectors. There is only
one SMA pair installed (J2 and J3) on the board. J2 connects to the pin 4 pf the RJ45 connector
(J1); J3 connects to the pin 5 of J1. The end user may access the remaining RJ45 pins using the
copper pads located on the bottom of the board.
Figure 2.
SMA2RJ45EVK Drawing
Page 4 of 4
