Each carton contains one top section, one bottom
section (larger trees include one or more middle
sections) and tree stand.
1. Unfold the tree stand and insert the eye bolt. Remove
packing material from ends of poles. Put bottom
section pole into tree stand making sure it is seated
properly (Figure 1). Tighten eye bolt until bottom is
held securely.
2. With tree in desired position for display, rest your foot
on the tree stand and pull the section sleeve up and
off.
3. Insert the top tree section into the lower tree
assembly and remove the section sleeve (Figure 2).
Trees with Middle Section(s)
Some of the taller trees will include one or more
middle sections. Each section will be numbered in
ascending order. The tree bottom section (which
inserts into tree stand) will be number
1
. The next
section as you build up, will be number
2
. Section
3
will follow until assembly is completed by inserting
tree top section.
Insert the middle section(s) as necessary removing
the sleeve one section at a time (Figure 3). Remove
sleeve from the top section and insert it into the
section below.
4. Branches should fall into place following removal of
sleeve. If any branches remain upright, gently lower
them into proper position.
5. Plug the electrical cord from the tree into a power
supply.
During tree assembly or disassembly, DO NOT DIS-
CONNECT any of the factory connected light strings
that are located on the center pole or within the tree.
DUAL COLOR
®
TREE
OPERATING INSTRUCTIONS
The foot switch operates the functions of the lights.
There are nine functions, each one is activated with
the press of the foot switch. Functions occur in the
following order:
Steady warm white; Steady multicolor; Fading warm
white; Fading multicolor; Warm white fading to
multicolor; Flashing warm white; Flashing multicolor;
Flashing warm white to multicolor (slow); Flashing
warm white to multicolor (fast)
Light functions always follow this sequence.
Fig. 3
Fig. 1
BULB REPLACEMENT INSTRUCTIONS
STORAGE
Remove the tree stand. Bring all branches to their original upright/compressed position and secure each section in its protective
sleeve. All tree parts can be placed in original carton and should be stored in a cool, dry area.
National Tree Company
2 Commerce Drive, Cranford, New Jersey 07016 USA
www.nationaltree.com
1. Unplug light string from power source.
2. Pull up on the Base Lock™ unlatching the bulb from the bulb socket. Gently pull the
bulb straight out.
3. Carefully insert new bulb into socket (bulb is keyed and only goes in one way) and
push down Base Lock until it snaps into place.
Fig. 2
Made in China
