2 Commerce Drive, Cranford, New Jersey 07016 USA
www.nationaltree.com
LEG ASSEMBLY
Tree stand is packaged with legs folded in downward
position; four locking pins are packed separately.
Before use, each leg must be pulled up from lower
position and locked into place.
Bring a leg completely up and insert a locking pin
into the hole of the leg. Repeat this procedure for
remaining three legs (see photo at right).
Remove the four pins and fold the legs back down
for storage in original box.
FUSE REPLACEMENT INSTRUCTIONS
RISK OF FIRE.
Do not replace attachment plug. Contains a
safety device (fuse) that should not be removed. Discard
product if the attachment plug is damaged.
Follow these steps to replace a burnt out fuse.
1. Unplug tree stand from power source.
2. Fuses are located in the plug. Slide the fuse access cover
away from cord side (in direction of arrow, Figure 1)
exposing fuses. Spare fuse is also inside compartment.
3. Remove fuse from compartment and examine. Replace
burnt out fuse with new one (5A, 120V only).
4. Close fuse compartment by sliding access cover back in
towards cord side of plug (Figure 2).
Fig. 2
Fig. 1
RS2 3/11
SAVE THESE INSTRUCTIONS
