As shipped, the folder is positioned to correctly bind in the full zig-zag mode. Straight stitching will require
moving the folder to the left. Adjustment instructions per Figure 2 follows.
1. The slot in the folder bracket allows it to be moved left or right when changing between zig zag and
straight on the stitch control.
2.
Caution:
Keep the presser foot needle block assembly from hitting the folder by allowing
approximately 1/8'' space between them.
3. When correctly adjusted the folder positions can be marked on a piece of masking tape applied at the
front edge of the folder.
4. Use of the guide bar is optional. If used it should be far enough to the right so it doesn’t block the
folder opening.
5. Threading the binding tape through only one of the tape guides (the one closest to the opening) is
recommended.
6. If stitch misses the tape on the bottom see page 23.
Page 15
FOLDERS
FOLDER
OPENING
1/8"
GUIDE BAR
ADJUSTMENT SLOT
STRAIGHT
ZIG ZAG
TAPE
TT
GUIDE
Figure 2
Figure 1